VIVOTEK
User's Manual - 235
* This is kept for compatibility.
uart_httptunnel <boolean> 0/7 Indicate whether to support HTTP tunnel for
UART transfer.
transmission_mode Tx,
Rx,
Both
0/7 Indicate transmission mode of the machine:
TX = server, Rx = receiver box, Both = DVR.
network_wire <boolean> 0/7 Indicate whether to support Ethernet.
network_wireless <boolean> 0/7 Indicate whether to support wireless.
network_dualmode <boolean> 0/7 Indicate whether network dual mode is
supported.
* Only available when
"capability_network_wireless" is "1".
* We support this parameter when the version
number (httpversion) is equal or greater than
0305a.
wireless_s802dot11b <boolean> 0/7 Indicate whether to support wireless
802.11b+.
wireless_s802dot11g <boolean> 0/7 Indicate whether to support wireless 802.11g.
wireless_s802dot11n <boolean> 0/7 Indicate whether to support wireless 802.11n.
wireless_beginchannel 1 ~ 14 0/7 Indicate the begin channel of wireless network
wireless_endchannel 1 ~ 14 0/7 Indicate the end channel of wireless network
wireless_encrypt_wep <boolean> 0/7 Indicate whether to support wireless WEP.
wireless_encrypt_wpa <boolean> 0/7 Indicate whether to support wireless WPA.
wireless_encrypt_wpa2 <boolean> 0/7 Indicate whether to support wireless WPA2.
wireless_apmode_enable <boolean> 0/7 Indicate whether wireless AP mode is
supported.
* Only available when
"capability_network_wireless" is "1".
* We support this parameter when the version
number (httpversion) is equal or greater than
0305a.
wireless_apmode_ssidpref
ix
<string> 0/7 Indicate the prefix of broadcasted SSID when
camera is in wireless AP mode.
To Next Page
Loading...
