Vivotek FD8366-V - Page 240

VIVOTEK
240 - User's Manual
minpan 0, <positive integer> 0/7 The lower limit for pan position.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
maxpan 0, <positive integer> 0/7 The upper limit for pan position.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
minpanangle <integer> 0/7 The lower limit for pan angle.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
maxpanangle <integer> 0/7 The upper limit for pan angle.
*Only available when bit0 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
tiltspeedlv 0, <positive integer> 0/7 The maximum speed level of tilt motion.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
mintilt 0, <positive integer> 0/7 The lower limit for tilt position.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
maxtilt 0, <positive integer> 0/7 The upper limit for tilt position.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
mintiltangle <integer> 0/7 The lower limit for tilt angle.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
maxtiltangle <integer> 0/7 The upper limit for tilt angle.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildinpt" is
"1"
zoomspeedlv 0, <positive integer> 0/7 The maximum speed level of zoom motion.
*Only available when the value of
"capability_camctrl_c<0~(n-1)>_zoommodule"
is "1"