Vivotek FD836B-(E)HVF2 - Page 190

VIVOTEK
190 - User's Manual
"capability_image_c<n>_basicsetting" is 1
gammacurve 0~100 4/4 0: Fine-turned gamma curve by Vivotek.
1: Gamma value = 0.01
2: Gamma value = 0.02
3: Gamma value = 0.03
...
100: Gamma value = 1
* Note: Although we set gamma value to 100
level, but not all gamma values are valid.
Internal module will take the closest valid one.
For example, 1~45 may all be mapped to
gamma value = 0.45, etc.
lowlightmode
<product dependent>
<boolean> 4/4 Enable/disable low light mode.
* Only available when
"capability_image_c<n>_lowlightmode" is 1
dnr_mode
<product dependent>
<boolean> 4/4 3D noise reduction.
0:disable
1:enable
* Only available when
"capability_image_c<n>_dnr" is 1
dnr_strength
<product dependent>
1~100 4/4 Strength of 3DNR
* Only available when
"capability_image_c<n>_dnr" is 1
defog_mode
<product dependent>
<boolean> 4/4 Enable/disable defog mode.
0:disable
1:enable
* Only available when
"capability_image_c<n>_defog_mode" is 1
defog_strength
<product dependent>
1~100 4/4 Strength of defog
* Only available when
"capability_image_c<n>_defog_mode" is 1
eis_mode
<product dependent>
<boolean> 4/4 Electronic image stabilizer
0:disable
1:enable
* Only available when 'eis' is listed in
"capability_image_c<n>_is_mode".
eis_strength
<product dependent>
1~100 4/4 Strength of electronic image stabilizer
* Only available when 'eis' is listed in
"capability_image_c<n>_is_mode".