Vivotek FD9369 - Page 225

VIVOTEK
User's Manual - 225
© 2020 VIVOTEK INC. All Right Reserved
100
NAME VALUE SECURITY
(get/set)
DESCRIPTION
sharpnesspercent 0~100 4/4 Set sharpness in the normalized
range.
0: Softer <-> 100: Sharper
* Only available when bit 3 of
"capability_image_c<0~(n-1)>_basicse
tting" is 1
gammacurve
<product
dependent>
0~100 4/4 0: Fine-turned gamma curve by
Vivotek.
1: Gamma value = 0.01
2: Gamma value = 0.02
3: Gamma value = 0.03
...
100: Gamma value = 1
* Note: Although we set gamma value
to 100 level, but not all gamma values
are valid. Internal module will take the
closest valid one. For example, 1~45
may all be mapped to gamma value =
0.45, etc.
* Only available when
"capability_image_c<0~(n-1)>_gamm
acurve" is 1
lowlightmode
<product
dependent>
<boolean> 4/4 Enable/disable low light mode.
* Only available when
"capability_image_c<0~(n-1)>_lowligh
tmode" is 1
hlm
<product
dependent>
<boolean> 4/4 Enable/disable hightlight mask.
* Only available when
"capability_image_c<0~(n-1)>_hlm" is
1
dnr_mode
<product
dependent>
<boolean> 4/4 3D noise reduction.
0:disable
1:enable
* Only available when
"capability_image_c<0~(n-1)>_dnr" is
1
© 2020 VIVOTEK INC. All Right Reserved
101
NAME VALUE SECURITY
(get/set)
DESCRIPTION
dnr_strength
<product
dependent>
1~100 4/4 Strength of 3DNR
* Only available when
"capability_image_c<0~(n-1)>_dnr" is
1
defog_mode
<product
dependent>
<boolean> 4/4 Enable/disable defog mode.
0:disable
1:enable
* Only available when
"capability_image_c<0~(n-1)>_defog_
mode" is 1
defog_strength
<product
dependent>
1~100 4/4 Strength of defog
* Only available when
"capability_image_c<0~(n-1)>_defog_
mode" is 1
eis_mode
<product
dependent>
<boolean> 4/4 Electronic image stabilizer
0:disable
1:enable
* Only available when 'eis' is listed in
"capability_image_c<0~(n-1)>_is_mod
e".
eis_strength
<product
dependent>
1~100 4/4 Strength of electronic image stabilizer
* Only available when 'eis' is listed in
"capability_image_c<0~(n-1)>_is_mod
e".
dis_mode
<product
dependent>
<boolean> 4/4 Digital image stabilizer
0:disable
1:enable
* Only available when 'dis' is listed in
"capability_image_c<0~(n-1)>_is_mod
e".
dis_strength
<product
dependent>
1~100 4/4 Strength of digital image stabilizer
* Only available when 'dis' is listed in
"capability_image_c<0~(n-1)>_is_mod
e".