Vivotek FD9369 - Page 247

VIVOTEK
User's Manual - 247
© 2020 VIVOTEK INC. All Right Reserved
122
NAME VALUE
SECURITY
(get/set)
DESCRIPTION
to use this> "capability_motion_wintype" =
rectangle.
* Only available when qvga is listed in
"capability_motion_windomain".
* It's recommended to use polygonsd
* This parameter will not be used after
the version number (httpversion) is equal
or greater than 0400a.
width
<Not recommended
to use this>
0 ~ 320 4/4 Width of motion detection window.
* Only available when
"capability_motion_wintype" =
rectangle.
* Only available when qvga is listed in
"capability_motion_windomain".
* It's recommended to use polygonsd
* This parameter will not be used after
the version number (httpversion) is equal
or greater than 0400a.
height
<Not recommended
to use this>
0 ~ 240 4/4 Height of motion detection window.
* Only available when
"capability_motion_wintype" =
rectangle.
* Only available when qvga is listed in
"capability_motion_windomain".
* It's recommended to use polygonsd
* This parameter will not be used after
the version number (httpversion) is equal
or greater than 0400a.
7.17 Tampering Detection Settings
Group: tampering_c<0~(n-1)> for n channel products (capability_tampering > 0)
n denotes the value of "capability_nvideoin"
NAME VALUE SECURITY
(get/set)
DESCRIPTION
enable <boolean> 4/4 Enable or disable tamper detection.
© 2020 VIVOTEK INC. All Right Reserved
123
NAME VALUE SECURITY
(get/set)
DESCRIPTION
threshold 0~100 4/4 Threshold of tamper detection.
duration 10~600 4/4 If tampering value exceeds the
"threshold" for more than "duration"
second(s), then tamper detection is
triggered.
ignorewidth 0,<positive
integer>
1/7 Indicate the width to offset to start to
analysis the image.
dark_enable <boolean> 4/4 Enable or disable image too dark
detection
dark_threshold 0~100 4/4 Threshold of image too dark detection
dark_duration 1~10 4/4 If image too dark value exceeds the
"threshold" for more than "duration"
second(s), then image too dark
detection is triggered.
bright_enable <boolean> 4/4 Enable or disable image too bright
detection
bright_threshold 0~100 4/4 Threshold of image too bright
detection
bright_duration 1~10 4/4 If image too bright value exceeds the
"threshold" for more than "duration"
second(s), then image too bright
detection is triggered.
blurry_enable <boolean> 4/4 Enable or disable image too blurry
detection
blurry_threshold 0~100 4/4 Threshold of image too blurry
detection
blurry_duration 1~10 4/4 If image too blurry value exceeds the
"threshold" for more than "duration"
second(s), then image too blurry
detection is triggered.
7.18 DDNS
Group: ddns (capability_protocol_ddns > 0)
NAME VALUE SECURITY
(get/set)
DESCRIPTION