Vivotek FD9369 - Page 259

VIVOTEK
User's Manual - 259
© 2020 VIVOTEK INC. All Right Reserved
134
NAME VALUE SECURITY
(get/set)
DESCRIPTION
nmotion <positive integer> 0/7 The number of motion window.
nmotionprofile 0, <positive integer> 0/7 Number of motion profiles.
nevent 0, <positive integer> 0/7 Number of event.
* We support this parameter when
the version number (httpversion) is
equal or greater than 0311c.
nrecording 0, <positive integer> 0/7 Number of recording.
* We support this parameter when
the version number (httpversion) is
equal or greater than 0309a.
ptzenabled 0, <positive integer> 0/7 An 32-bit integer, each bit can be set
separately as follows:
Bit 0 => Support camera control
function;
0(not support), 1(support)
Bit 1 => (only available when bit0 is 1)
Built-in or external video source;
0(external), 1(built-in)
Bit 2 => (only available when bit0 is 1)
Support pan operation;
0(not support), 1(support)
Bit 3 => (only available when bit0 is 1)
Support tilt operation;
0(not support), 1(support)
Bit 4 => (only available when bit0 is 1)
Support zoom operation;
0(not support), 1(support)
(only available when RS-485 interface
is supported or SD/PZ/PT/PD/video
server series)
Bit 5 => (only available when bit0 is 1)
Support focus operation;
0(not support), 1(support)
(only available when RS-485 interface
is supported or SD/PZ/PT/PD/video
© 2020 VIVOTEK INC. All Right Reserved
135
NAME VALUE SECURITY
(get/set)
DESCRIPTION
server series)
Bit 6 => (only available when bit0 is 1)
Reserved bit; always 0.
Bit 7 => (only available when bit0 is 1)
External or built-in PT;
0(built-in), 1(external)
windowless <boolean> 0/7 Indicate whether to support
windowless plug-in.
evctrlchannel <boolean> 0/7 Indicate whether to support HTTP
tunnel for event/control transfer.
joystick <boolean> 0/7 Indicate whether to support joystick
control.
remotefocus
<Not
recommended to
use this>
0,<positive integer> 0/7 An 4-bit integer, which indicates the
supportive application of
remotefocus.
If the value of this parameter is larger
than 0, it means that the camera
supports remotefocus function.
bit 0 => Indicate whether to support
both zoom and focus function.
bit 1 => Only support zoom function.
bit 2 => Only support focus
function.
bit 3 => Currently, this is a reserved
bit, and the default value is 0.
* It's strongly non-recommended to
use this.
* This is reserved for compatibility
and will not be used after the version
number (httpversion) is equal or
greater than 0400a.
* We replace
"capability_remotefocus" with "
capability_image_c0_remotefocus".
npreset 0, <positive integer> 0/7 Number of preset locations