Vivotek FD9369 - Page 405

VIVOTEK
User's Manual - 405
© 2020 VIVOTEK INC. All Right Reserved
280
8.28 Preset Locations
(capability_camctrl_c<0~(n-1)>_zoommodule = 1)
Note: This request requires Operator privileges.
Method: GET/POST
Syntax:
http://<servername>/cgi-bin/operator/preset.cgi?[channel=<value>]
[&addpos=<value>][&delpos=<value>][&return=<return page>]
PARAMETER VALUE DESCRIPTION
addpos string[30] Add one preset location to the preset list.
channel 0~"capability_nvideoin"-1
Channel of the video source.
delpos string[30] Delete preset location from preset list.
return <return page> Redirect to the page <return page> after the parameter
is assigned. The <return page> should be the relative
path according to the root of camera. If you omit this
parameter, it will redirect to an empty page.
* If the <return page> is invalid path, it will ignore this
parameter.
8.29 SmartSD (capability_localstorage_smartsd > 0)
Note: This request requires Administrator privileges.
Method: GET/POST
Syntax:
http://<servername>/cgi-bin/admin/smartsd.cgi?function=<value>
© 2020 VIVOTEK INC. All Right Reserved
281
PARAMETER VALUE DESCRIPTION
function getstatus Function type
getstauts : Information of smartSD internal status return
value as below:
smartsd_lifetime_num:
Accumulated amount of data that has been written
smartsd_lifetime_den:
Card-guaranteed amount of data that can be written
smartsd_lifetime_rate:
The ratio of smartsd_lifetime_num to
smartsd_lifetime_den.
It means the accumulated percentage amount of flash
block has been written. The
range is from 0 to 100 (unit: %).
The SD card is recommended to be replaced if the
percentage reaches above 90%.
smartsd_spare_block_rate:
Usage rate of spare blocks.
It means the usage percentage of total spare block. The
range is from 0 to 100 (unit: %). The SD card is
recommended to be replaced if the percentage reaches
above 90%.
smartsd_data_size_per_unit:
Size (in sectors) of data to be written when Life
Information1 is updated.
smartsd_num_of_sudden_power_failure:
Indicates how many times power disconnection occurred during write/erase
operations
smartsd_operation_mode:
Enables/disables power-off detection and write error notification
smartsd_attached:
Indicate the smartSD is attached or not.
8.30 Connect to AP (capability_network_wireless > 0)
Note: This request requires Administrator privileges.
Method: GET/POST