VIVOTEK
User's Manual - 7
Hardware Installation
0002D10766AD
XXXXXX
1. Jot down the camera's MAC address for later reference.
< 10 kgf-cm
2. Find an appropriate position. Drill holes on the wall for the included plastic anchors.
Install the camera by driving screws through the mounting holes on the bracket. The
anchors may not be necessary if you install the camera on a wooden wall or calcium
silicate board. If preferred, drill a routing hole on the wall for routing the power cord.
If you need to route cables along the wall, use a pincer to remove the break-off tabs.
To Next Page
Loading...
Need help?
General
