VIVOTEK
User's Manual - 107
A green bar indicates that even though motions have been detected, the event has not been triggered
because the image variations still fall under the dened threshold.
If you want to congure other motion detection settings for a different time period within a day, please
click Prole to open the Motion Detection Prole Settings page as shown below. A total of three motion
detection windows can be congured on this page as well.
Please follow the steps beolw to set up a prole and additional motion detectio windows in it:
1� Create a new motion detection window�
2� Check Enable this prole�
3� Select the applicable span of time in the Schedule mode� Please manually enter a time range if you
choose Schedule mode�
4� Click Save to enable the settings and click Close to exit the page�
This motion detection window will also be displayed on the Event Settings page� You can go to Event >
Event settings > Trigger to choose it as a trigger source� Please refer to page 111 for detailed information�
Percentage = 30%
Video(TCP-AV)
2010/12/10 17:08:56
corridor
2013/01/18 14:39:12
To Next Page
Loading...
