Vivotek SD9366-EH - Page 322

VIVOTEK
User's Manual - 322
© 2020 VIVOTEK INC. All Right Reserved
156
PARAMETER VALUE SECURITY
(get/set)
DESCRIPTION
maxtilt 0, <positive integer> 0/7 The upper limit for tilt position.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildin
pt" is "1"
mintiltangle <integer> 0/7 The lower limit for tilt angle.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildin
pt" is "1"
maxtiltangle <integer> 0/7 The upper limit for tilt angle.
*Only available when bit1 of
"capability_camctrl_c<0~(n-1)>_buildin
pt" is "1"
zoomspeedlv 0, <positive integer> 0/7 The maximum speed level of zoom
motion.
*Only available when the value of
"capability_camctrl_c<0~(n-1)>_zoomm
odule" is "1"
minzoom 0, <positive integer> 0/7 The lower limit for zoom position.
*Only available when the value of
"capability_camctrl_c<0~(n-1)>_zoomm
odule" is "1"
maxzoom 0, <positive integer> 0/7 The upper limit for zoom position.
*Only available when the value of
"capability_camctrl_c<0~(n-1)>_zoomm
odule" is "1"
maxdzoom 0, <positive integer> 0/7 The upper limit for digital zoom
position.
*Only available when the value of
"capability_camctrl_c<0~(n-1)>_zoomm
odule" is "1"
focusspeedlv 0, <positive integer> 0/7 The maximum speed level of focus
motion.
*Only available when the value of
"capability_camctrl_c<0~(n-1)>_zoomm
odule" is "1"