NEW ENGINE BREAK-IN PERIOD
The engine on your new Viza™ scooter must be gradually
broken-in to assure engine longevity. For the first 2 hours of
use (or 1 gas tank of fuel), do not accelerate abruptly or operate
at high engine speeds. Vary the throttle input up and down
while riding to correctly break-in your engine.
DRIVE BELTS
Your Viza™ motor scooter is equipped with a belt reduction
and belt drive system. Proper care is required to achieve maxi-
mum durability. Avoid ‘slamming’ the rear brakes on causing
the rear tire to “lock-up” as this puts severe strain on the belt
drive system of your scooter and can shorten the life of your
belt or damage the drive system. Proper belt tension is also
very important. The main reduction belt is tensioned auto-
matically by the rubber engine mounts. The drive belt that
turns the rear tire is tensioned by two drive belt tensioning
bolts located at the rear of your scooter. To tighten the belt
tension, first loosen the two rear axle bolts. Next, tighten the
two drive belt tensioning nuts by turning them clockwise until
the belt is properly tensioned. You should have about 1/4” to
1/2” of play in the belt. Tighten the two rear axle nuts to com-
plete.
DRIVE BELT TENSIONER
REDUCTION BELT
To Next Page
Loading...