4
Remove the battery cover
by gently sliding it away
from the remote.
5
Insert the included batteries
and gently slide the battery
cover back into place.
6
Turn your TV on, the Sound Bar will automatically
turn on and begin searching for an active input.
The LED indicators on the front of the Sound Bar will
begin cycling in pairs through inputs until an audio
source is detected.*
You can press the INPUT button to switch between
audio sources. For example, if you connected your
TV to Input 1, set the Sound Bar to Input 1.
PowerInput
Top Top
Tip: Pressing the INPUT button will
stop the auto detect function.
* Auto detect function only occurs once when the Sound Bar is rst powered on. To enable this feature again, you must do a Factory
Reset (see the
Using Button Combinations
section for more information) or press and hold the INPUT button for 3 seconds.
10
To Next Page
Loading...
Need help?
General
