6Installation
Setting the Volume
Ringer Volume Switch
This switch is located on the right side of the telephone. You may set the
ringer volume switch to HI, LO, or OFF. When the switch is moved to the
OFF position you will not hear ringing from that telephone. However, an
extension telephone using the same line will ring during an incoming call.
Tw o-Li ne Mod els --- The 2803 telephone has two volume switches, one for
each line. This hospitality model does not have an OFF position, the
volume can only be changed to HI or LO.
B/Z -Type Ringer
The B/Z Ringer switch is located on the right side of the telephone near
the Ringer Volume switches. This switch should be set to “B” for residential
use, and “Z” for business/hospitality applications.
Handset Volume
Each 2800-model telephone has a volume button that allows you to
increase or decrease the handset volume while on an active call. The
settings are: Normal and High.
Speakerphone Volume Switch
Speakerphone models (2802 & 2803) are equipped with a sliding volume
switch to adjust the speakerphone volume. Slide the switch toward you
for lower volume, or away from you for higher volume.
Acc essing th e Dire cto ry Card
Frequently dialed numbers may be recorded on the Directory Card. For
models with speed dial memory, the card can be used to record the
telephone numbers stored in One-Touch speed dial memory.
To remov e the ca rd:
1. Insert a paper clip in the hole at the top of the vinyl overlay
covering the card.
2. Lift the overlay and remove the card.
The MSG li ght and the Line In Use (LIU) LEDs will not operate when set
in the “B” ringe r mode.
To Next Page
Loading...
Need help?
General
