10 Operation
Conferencing (2803 model)
To initiate a conference call:
1. Press a LINE button and dial the first party’s telephone number.
2. When the first party answers, advise them that a conference call is
being established and press the HOLD button.
The -green- Line indicator will extinguish, and the Hold indicator
will illuminate -red- for that line.
3. Press the o ther LINE button; di al second par ty’s telephone number.
4. When the second party answers, advise them of the conference call
and then press the CONF button.
» The first call will be released from Hold and you will be able to
converse with both par ties at the same time.
» The -red- Conference LED illuminates steady, and the -green-
LEDs for both lines will remain lit.
If the se con d part y’s li ne i s b usy:
Press the first LINE button to return to the first party.
The first party is released from Hold; resume your conversation.
To terminate a conference call:
1. Hang up the handset, or press the SP KR button if in SPKR mode.
Both Line indicators will extinguish.
2. Press the CONF button in order to terminate this function.
To talk with only one party from the conference:
1. Press the LINE button for the desired conversation.
The -red- Conference LED will extinguish; Line LED will light steady
for selected line; the other line will be disconnected.
2. Resume the conversation.
To end a conference, placing both lines on Hold:
Press the HOLD button.
The -red- Conference LED will extinguish, and the LIU LEDs will light
steady -red-. Both first and second parties are placed on Hold.
If the CONF button is not pressed after you hang up, both
lines will be accesse d si multaneously the next time the
telephone is used.
To Next Page
Loading...
