The replacement for light signal
·If there is no light signal, you may be in danger, because the light helps others easily pay attention to you and your
motorcycle.
Please replace the broken lights.
·The headlight, front position light, turning signal light, rear position light, brake light and registration plate light are all LED
and sealed, in case broken, go to the service station for replacement. The replacement for lights please follow the
description and specification below:
The dirt especially the grease on light's surface may be bad for heat radiation, which lead to light overheat even reduce
its working life.
When a signal light is broken, replace for a new one with completely same rating power and specification,
otherwise the different one may lead to electrical circuit overload or light broken very early.
!
Warning
60
Parameters for electrical system
Battery specification
12V8Ah
Headlight (High/Low beam)
12V 33W/14W
Front
position light
12V 4.8W
Rear position light
12V 0.5W
Rear brake light
12V 12.6W
Front turning signal light
12V 1.2W
Rear turning signal light
12V 6W
Rear registration plate light
12V 0.257W
Specification for fuse chip
30A, 25A, 15A, 10A
To Next Page
Loading...
