Instruction and Operating Manual
Overspeed Protector CTO-B45202
J.M. Voith SE & Co. KG │ Division Digital Ventures
8 Decommissioning
Disposal
For overspeed protector disposal, please observe the local applicable provisions on
protection of the environment. The servomotor essentially contains steel, copper, synthetic
materials, electronic components, and residual oil.
If the overspeed protector is switched off for repair or inspection purposes, or for a
system shutdown, switch off the oil supply system and release all pressure
accumulators, if effective.
Wear protective glasses when disassembling the hydraulic connection on the
Disconnect the 24 V DC power supply and remove the lines. Remove the piping. This
may result in larger oil quantities leaking out. Collect the oil in a suitable container and
dispose of it properly. Close all openings. Now the overspeed protector can be cleaned
and packed.
To Next Page
Loading...
