1.7 Thermostat - remove and install
Special tools and workshop
equipment required
♦ Refractometer for cooling
system fluid analysis -
T10007-
♦ Tray -V.A.G 1306-
♦ Torque wrench - 5 to 50 Nm
( enc. 1/2") -VAG 1331-
♦ Standart-type clamp pliers -
VAS 5024A-
1.7.1 Removal
Note
Always replace seals and gaskets.
– Drain the cooling system ⇒ page 76 .
– Remove alternator ⇒ Rep. Gr. 27 .
– Remove the cooling system hose from the connection flange.
Fox 2004 ➤
3 - Cyl. diesel engine - Edition 02.2009
82 Rep. Gr.19 - Cooling system