11
12
Fold series
www.ridevoltag.com
PEDAL ASSIST: When you are in PAS mode – Do not pedal around corners – you will get a boost
and your pedal will hit the ground and can cause injury or death! Do not use pedal assist on level
and downhill grades if people are visible on the path or boardwalk. Do not use pedal assist if small
children or pets are within 100 feet.
HELMET USAGE:
MECHANICAL SAFETY CHECK:
SMALL BICYCLE ACCESSORIES AND CHOKING HAZARD: Some Bicycle accessories may
present a choking hazard and other hazard to small children. Keep any bike parts accessories,
tools away from small children.
USING GOOD JUDGMENT: Make sure no straps are dangling where they could get caught in the
wheels – No bags, boxes or any items should be placed in a position where they could get caught
in the spokes Double check your load for security and stability. Check to see that your wheels are
securely fastened and that no components or frame members are cracked or broken (in general, if
at any time you notice a crack or bend in your bike, stem, forks, or bars of your bicycle, stop riding
immediately; take your bike to your local bike shop and have them inspect it).
Always wear an approved helmet and ensure it fits according to the manufacturers’
instructions.
Ensure your helmet meets the latest certification standards and is appropriate for the type of
riding you do – and if there are any special requirements for riding an electric bike.
Most serious bicycle injuries involve head injuries, which might have been avoided if the rider
had worn an appropriate helmet. FAILURE to wear a helmet when riding may result in serious
injury or death.
Check the condition of your Electric Bike before every ride.
Make sure no nuts, bolts or fixings are loose, and pay particular attention to the axle, nuts and
handlebar stem.
Make sure the tires are correctly inflated with the recommended air pressure, which can be
found on the rim of every tire.
Check the brakes for proper operation.
Please shut off the power when the bike is unused.
Use the original replacement parts, and ask a local bike shop to install the part;
Replace the tires when the tires are damaged or worn.
To clean the surface of the bike, use a soft cloth dipped in some water and wipe off any stain. If the stain is
hard to clean, apply some toothpaste and useatoothbrush to scrub, then wipe it again with a wet cloth.
Note: Do not use alcohol, petrol, kerosene or other corrosive, volatile chemical solvents to clean the bike, as
they will damage the appearance internal structure of the components.
Do not useawater hose with pressure to rinse as this might damage the electrical components.
While cleaning, make sure your e-bike is powered off, the charging cable is unplugged and the charging port is
covered. Failing to do so might result in an electric shock or damage.
Please store your bike in a dry and cool indoor place when not in use.
Maintenance
Maintaining your E-bike battery
When not using the bike for longer periods of time, make sure to keep your battery charged. As leaving
the battery uncharged for long periods of time will damage the battery cells and void warranty. Our
battery packs containaboard recording the charge and discharge status of the battery.
Do not charge the battery longer than needed and unplug the charger when the status light turns green.
A damaged battery cannot be restored.
Note: Do not disassemble the battery pack as this might result inaserious accident or electric shock
when causingashort circuit.
Lubricating parts (see below table)
Cleaning your bike
Part Frequency Recommended oil for lubricating
Front fork set
Yearly
Y
early
Yearly
Yearly
Lubricating grease
Lubricating grease
Lubricating grease
Lubricating grease
Front/rear axle
Bottom Bracket
Pedal axle
Chain wheel
Chain
Freewheel interior
Brake lever
Weekly
Weekly
Monthly
Monthly
Lubricating oil
Lubricating oil
Lubricating oil
Lubricating oil
Make sure not to contaminate the brake rotors and pads with oil or grease as this
will damage the brake system.
To maintain good battery health, please store your battery at temperatures between 20°C - 50°C, failing
to do so might damage the battery cells or lead to overheating of the battery.
To Next Page
Loading...