VOLTCRAFT DT-30LK - Non-Contact Measurement Procedure

Sequence 1 Function
RPM Revolutionsperminute(non-contact)
↓
rPm Revolutionsperminute(contactviacone)
↓
HZ Frequency (contact-free + contact via cone)
↓
M/M Meter per minute (contact via cone)
↓
I/M Inch per minute (contact via cone)
↓
F/M Feet per minute (contact via cone)
↓
Y/M Yards per minute (contact via cone)
Sequence 2 Function
REV Totalnumberofrevolutions(non-contact+contactviacone)
↓
M Total distance in meter (contact via friction wheel)
↓
In Total distance in inches (contact via friction wheel)
↓
FT Total distance in feet (contact via friction wheel)
↓
Yd Total distance in yards (contact via friction wheel)
a) Non-contact measurement
1. Follow the steps above to select the desired unit of measurement.
2. Press and hold the MEAS button (6) to activate the laser (4).
3. Pointthelaserbeamatrightangleatthepositionofthereectivestrip.Thedistancebe-
tweenthemeasuringdeviceandthereectivestripshouldnotexceed3m.
27