VOLTCRAFT DT-30LK - Care and Cleaning

Proceed as follows to store and retrieve measured values:
1. Whenyouhavenishedmeasuring,presstheMEM button (2) while holding down the MEAS
button (6). The values from the current measuring procedure are stored. The display jumps
to the next data set.
2. ReleasetheMEAS button and conduct further measurements as needed.
3. To retrieve stored values, repeatedly press the MEM button until the desired data set ap-
pears on the bottom right of the display (3). The last registered value from the stored meas-
uring process is shown in the middle of the display.
4. Press the MEMbuttonbrieytotogglebetweenthemaximumvalue,minimumvalueand
average value. This applies only to values stored in Sequence 1.
Stored values remain in the memory even if you replace the battery.
You can overwrite old values by selecting any memory cell, conducting measurements
and storing the values following the above steps.
There are no maximum/minimum/average values for the functions from Sequence 2
(REV,M,In,FTandYd).
11. Care and cleaning
Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solu-
tions as they can cause damage to the housing and malfunctioning.
Do not immerse the product in water.
• The device is maintenance-free apart from occasional cleaning.
• Cleantheproductwithadry,bre-freecloth.
• Use a longhaired, soft and clean brush and a vacuum cleaner to easily remove dust.
29