Need help?Do you have a question about the VOLTCRAFT GDM 704 and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Temperature Measurement | -40 °C to 1000 °C |
| Interfaces | USB |
| Calibration | Manual |
| Power supply | 9 V battery |
| Diode Test | Yes |
| Continuity Test | Yes |
| Measurement categories | CAT III 600 V |
| DC Current Range | 0.01 μA - 10 A |
| AC Current Range | 0.01 μA - 10 A |
| Frequency Measurement | 10 MHz |
| Bandwidth | 40Hz to 400Hz |
| Battery | 9V |
Essential safety rules for operating the multimeter safely.
Identifies the multimeter's physical parts, including display and input jacks.
Explains display symbols, function keys (F1-F4), and modes.
Describes the numerical and graphical display outputs of the multimeter.
Details the meaning of various icons and symbols shown on the multimeter screen.
Illustrates amplitude and time division settings in graphical mode.
Provides fundamental steps for safe and effective use of the meter.
Covers manual/auto ranging and freezing readings with the Hold function.
Explains auto power off, lock-up, and critical safety for voltage measurements.
Step-by-step guides for V, mV, resistance, and continuity measurements.
Instructions for capacitance, diode testing, and mA AC/DC current measurements.
Details 20A current measurements and logic level detection.
Covers signal generation and using external adapters for measurements.
Explains configuring power-on settings and performing self-tests.
Details Min/Max recording, data storage, and frequency display modes.
Explains trigger level, duty cycle, pulse width, and period measurement functions.
Describes how to set and use the relative mode for comparative measurements.
Details capturing peak values and testing parameters against user-defined limits.
Covers dB display, time base, and voltage per division adjustments.
Explains trigger level adjustment and single measurement capture.
Details glitch capture and general guidelines for multimeter upkeep.
Provides instructions for safely replacing the meter's battery and fuses.
To Next Page