30
Display Parameter Possible rechargeable battery
programmes
The capacity is displayed. Charging (CHARGE)
Discharging (DISCHARGE)
Test (CHARGE/DISCHARGE TEST)
The runtime of the rechargeable
battery programme is displayed.
Charging (CHARGE)
Discharging (DISCHARGE)
Test (CHARGE/DISCHARGE TEST)
The rechargeable battery is
charged completely.
Charging (CHARGE)
Test (CHARGE/DISCHARGE TEST)
No measured value has been
determined yet. Wait until
the rechargeable battery pro-
gramme has been completed.
Test (CHARGE/DISCHARGE TEST)
Quick test (QUICK TEST)
The dynamic inner resistance of
the rechargeable battery cell is
displayed in Milli-Ohm (mΩ).
Quick test (QUICK TEST)
This parameter is set permanently.
The display is not switched with the
"DISPLAY" button.
“CURRENT” button
The “CURRENT” button permits setting of the charge and discharge current. Each push will
switch the display.
“SLOT” button
The “SLOT” button selects the current charging slot. Each push will switch the display (slot 1,
2, 3, 4, 1-4, end).
It is also used to conrm “MODE” and “CURRENT” parameter settings and ends the settings.
To Next Page
Loading...
