• Insert the rechargeable battery cell to be charged into a suitable free charging slot, observing the
correct polarity. Note the polarity information on the charging slot (+/-).
If the rechargeable battery is inserted incorrectly, an
optical and acoustic warning signal will be triggered
immediately. Insert the rechargeable battery, observ-
ing the correct polarity.
The charger now beeps once every second depending on the preset “Auto Charge” time. After this time
the charging process will start automatically.
The corresponding parameters will appear on the display.
If a cycle display time is preset, the parameters of the ac-
tive slots will be displayed automatically in succession. You
can also select slots manually using the arrow buttons.
The charger is equipped with a function to
measure the cell resistance of individual cells. The cell resistance will be measured after
approx. 10 seconds and calculated after the charging programme has been started. The very
low cell resistance value can feature a small deviation for different charging parameters. This
is technically unavoidable and not a malfunction.
Oncecharginghasnished,anacousticsignalwillbetriggeredandagreeddisplayindicationwillap-
pear at the slot position.
• When charging is complete, remove the corresponding rechargeable battery cell from the charger.
37
To Next Page
Loading...
Need help?
General
