30
Display Information and Symbols
This is a summary of all possible symbols and information on the DMM
AUTO Automatic range setting is active
MANU Symbol for manual range setting
HOLD Data-Hold function is active
OL Overload = the measuring range was exceeded
OFF Off The DMM is switched off
Symbol for battery change required
Symbol for the diode test
Symbol for the acoustic continuity tester
Symbol for display illumination
Direct/alternating current (AC/DC)?
DC Direct current for voltage and current
AC Alternating current for voltage and current
mV Millivolt (exp.–3)
V Volt (unit of electric potential difference or voltage)
A Ampere (unit of electric current)
mA Milliampere (exp.–3)
Ω Ohm (unit of electric resistance)
kΩ Kiloohm (exp.3)
MΩ Megaohm (exp.6)
nF Nanofarad (unit of electric capacity, exp.-9)
µF Microfarad (exp.-6)
mF Millifarad (exp.-3)
MAX Display of maximum value
MIN Display of minimum value
To Next Page