26
Controls
(see fold-out page)
1 LCD display
2 MAX/MIN button for max/min value display
3 HOLD button to “freeze” the displayed values
4 MODE/REL button to switch to double-allocated measuring functions (AC/DC, continuity test and
diode test) and relative measurement in low Ohm range
5 Dial switch
6 Light button to switch the display illumination on
7 Attachment fitting (for holding strap etc.)
8 Foldable mounting brackets
9 Battery compartment
10 Red measuring socket “E1” for all 2-lead measuring functions (V, Ohm, CAP and mA; positive
potential)
11 Black measuring socket “E2” for all 2-lead measuring functions (COM; earth reference, negative
potential)
12 Black Kelvin measuring socket “P1” for all 4-lead low Ohm measuring functions (negative potential)
13 Red Kelvin measuring socket “P2” for all 4-lead low Ohm measuring functions (positive potential)
To Next Page
Loading...
