Probe sensor to measure and display electric parameters in the range of overvoltage category
CAT III up to 600V against earth potential, pursuant to EN 61010-1 and all lower categories.
• Measurement of direct and alternating voltage up to 600 V (CAT III)
• Measurement of direct and alternating current up to 200 A
• Measurement impedance values of up to 999.9 Ω
• Continuity test (acoustic)
• Non-Contact AC Voltage Detection
The device must only be operated with the specied battery/rechargeable battery type.
The meter must not be operated when it is open, i.e. with an open battery compartment or
when the battery cover is missing. Measurements in moist rooms or under detriment ambience
conditions such as wetness or high humidity, dust, ammable gases, vapours, solvents,
thunderstorm or strong electrostatic elds are not permissible.
For safety reasons, only use measuring lines or accessories which are adjusted to the speci-
cations of the meter when measuring.
Any use other than that described above damages the product. Moreover, this is linked to
dangers such as short circuit, re, electric shock, etc. No part of the product must be modied
or converted!
Read the operating instructions carefully and keep them for later reference.
Always observe the safety information!
• Probe sensor with hand loop
• 2 x battery type AAA
• Safety measuring cable
• Storage pocket with belt loop
• Operating Instructions
To Next Page
Loading...
Need help?
General
