59
Maintenance. Lubrication system
Switchable oil filters
IMPORTANT! Though possible, the switchable
filters should not be replaced during engine ope-
ration other than in case of an emergency
1. Clean the filter bracket.
2. Disconnect the left filter by turning the lever to
the right-hand end position. To unlock the lever,
pull the knob beneath the lever downwards.
3. Unscrew the left-hand oil filter and discard it. Use
a filter wrench if necessary.
4. Check that the mating surfaces on the filter
bracket are clean, and that no traces of the seal
from the old filter remain.
5. Oil the rubber seal for the new filter.
6. Screw the filter on by hand until the rubber seal
just touches the mating surface of the filter brack-
et. Then tighten the filter a further 3/4 of a turn.
7. Turn the lever to the left-hand end position and
change the right-hand oil filter in the same way.
8. Put the lever in operating position (straight up).
9. If necessary, top up the system with lubrication oil at
first stop. Refer to section “Lubrication oil change”.
To Next Page