67
Cylinder block
General
The cylinder block is made of cast iron with sides
which extend below the crankshaft for maximum
support. The cylinder bore is machined directly into
the block and is specially honed to minimize wear
and oil consumption.
Repair instructions
Cylinder block, replacement
(16A.01)
1
Drain the engine oil and the engine coolant system.
2
Remove the generator (GEN) drive belt, the genera-
tor (GEN) and the mounting brackets, see 22.
3
Remove the starter motor, operation 22B-01.
4
Remove the crankshaft pulley, operation 14A-01A.
5
Remove the cap for the timing cover, the timing
belt, belt pulleys and timing cover, see section 15.
6
Remove the oil pump and filter unit, operation 18A-
06.
7
Remove the fuel filter, injectors and fuel injection
pump, see section 19.
8
Remove the reverse gear.
9
Remove the flywheel and the flywheel cover.
To Next Page
Loading...
Need help?
General
