Volvo D20 - Page 28

Group 21 Reconditioning engine
Oisassembly
26
FlYWHEEl. CRANKSHAFT Oll SEAlS
B7
Remove pressure plate, driven plate and
flywheel
Unscrew clutch pressure plate mounting balts
crosswise a few turns at a time to prevent warp.
Use locking sector5112 to prevent
flywheel from mov-
ing.
B8
Remove hose connector at rear of block and
crankshatt rear oil seal
Pry out sea I with a screwdriver placed between sea I
and crankshaft.
Check pilot bearing
Replace bearing if damaged. Use puller 4090.
Remove crankshaft front oil seal
Use puller 5205.
B9
Bl0