Volvo D20 - Page 72

Group 21 Reconditioning engine
Installing parts
,
70
K17
Install pump plunger and vacuum pump
Lubricate plunger. Install plunger in same position as
before (c heck wear marks on end of plunger).
Install
new O-ring on vacuum pump. Apply sealer to
O-ring.
Install alternatar and adjusting braeket
Do not tighten retai ning balts at this stage.
K18
K19
Attach wiring harness to engine left side
Clamp wiring harness beneath thermestat housing.
Reconnect wiring.
Tie wiring harness to helder for air tube and at rear of
cylinde r block as i llustrated.
Clamp wiring harness to retaining balt for rear timing
gear cover.