Volvo D20 - Page 75

1334 99
Group 2 7 Recon di tio ning en gine
Instafling parts
K26
Reconnect wires to starter motor
Co nnect two thick red wi r es to st arter moto r and bluel
yellow wi re to sole n oid.
Attach right engine mount
Install engin e
K27
Refer to appropriate manual fo r installa tio n procedur e.
Import a nt l Cy linder hea d b olts must be retorqued af ter
the engine is
warmed-up. Follow the procedure below:
l. Run engine until the oil temperature is at least 50 °CI
(122°
F).
2. M 11 balt s: tor que bolts to 90 Nm (66 ft Ibs).
M 12 ba lt s: angle-t ighten bo l ts90 oin one movement
without stopping. Do no t slacken bolts first.
After driving 1000-2000 km (600-1200 miles) the cyl-
inder head balts must be lor qued again.
73