TSC1 control
The TSC1 message can be used to request speed/
torque instead of the VP70 message.
It is also possible to limit the permissible engine speed/
torque when shifting gear etc. by overriding the
demanded speed/torque request.
TSC1 messages can be received from the following
source addresses:
BB1
dec hex
TECU (transmission) 3 03 h
OEM (controller) 17 11 h
Transmission rate and TSC1 timeout
The expected Tx rate for 'Transmission rate' is 10ms.
Bus interface
Associated signals:
BB1: Rx: VP70 'Accelerator pedal position'
VP70 'Idle speed select'
TSC1 'Engine override control mode'
TSC1 'Override control mode priority'
TSC1 'Engine requested speed/speed limit'
TSC1 'Engine requested torque/torque limit'
TSC1 'Control purpose'
Engine control interface, TSC1 control
47706587 05-2015 © AB VOLVO PENTA 19
To Next Page
Loading...
