To Next PageTo Next PageWhat to do if Volvo Ingersoll Rand SD-160 TF shows low engine oil pressure?
If the red warning light illuminates due to low engine oil pressure in your Volvo Construction Equipment, first add oil to correct level. Then, stop the engine and check for lubrication system leaks, tighten any loose fittings on the oil line system.
What to do if my Volvo Ingersoll Rand SD-160 TF engine overheats?
If the engine of your Volvo Construction Equipment overheats, immediately stop the engine. The possible causes are: low engine oil level (add oil to correct level), a broken fan belt, low engine coolant level (replenish coolant to correct level), excessive dirt on radiator cooling fins or blocked air flow (clean cooling fins or clear blockage), a defective radiator cap, a defective thermostat, defective injector nozzles, or incorrect fuel pump calibration. For some of these issues you will need to call for specialist service to correct.
How to troubleshoot Volvo Ingersoll Rand SD-160 TF engine that will not start?
If your Volvo Construction Equipment engine won't start, it could be due to several reasons. Check if the emergency stop switch is depressed (pull it up to disengage), ensure the propulsion control lever is in the neutral or STOP position. Also, check for a defective Fuse 1 (replace it if needed), discharged batteries (charge them), or the battery master switch being OFF (turn it ON). Inspect the battery cable connections (tighten or connect if loose or disconnected). Other potential causes include a faulted in-line fuse link, starter relay, defective ignition switch, or a defective starter or starter solenoid. For the last four causes you must call for service to replace.
Why does the voltmeter indicate a low value on my Volvo Ingersoll Rand SD-160 TF?
If the voltmeter on your Volvo Construction Equipment indicates a low or negative value, the alternator speed might be too low. Check the belt tension and correct it if required. It could also be not charging due to a defective alternator or regulator, in that case call for specialist service.
Why is my Volvo Ingersoll Rand SD-160 TF Construction Equipment engine making excessive fumes?
If your Volvo Construction Equipment engine is making excessive fumes, it could be due to several reasons. The engine oil level might be too high (drain oil to correct level), the air cleaner element might be blocked (clean or replace it), or there might be low compression due to poor condition of the valves or incorrect valve clearance. In the last case call for specialist service to correct.
General| Brand | Volvo |
|---|---|
| Model | Ingersoll Rand SD-160 TF Series |
| Category | Construction Equipment |
| Language | English |
Information on ROPS, FOPS, seat belts, and battery master switch.
Understanding safety symbols, signal words (DANGER, WARNING, CAUTION), and labels.
General safety principles, personnel qualifications, operating instructions, and pre-start inspections.
Safety for maintenance, stopping, transporting, hazardous substances, and special dangers.
Key operational procedures and safety checks before operating the machine.
Detailed checks required before starting the machine.
Suggestions and checks during machine operation.
Instructions for towing the machine with or without a tow valve.
Key steps and precautions before performing maintenance.
Tasks at different intervals: daily, weekly, semi-annual, annual.
General introduction to troubleshooting procedures and safety.
Troubleshooting for fuse failures, relays, and diodes.
