09 Wheels and tyres
09
}}
* Option/accessory, for more information, see Introduction.
329
3. Place chocks in front of and behind the
wheels which will remain on the ground to
prevent them from rolling. Use heavy
wooden blocks or large stones for exam-
ple.
4. Cars with steel rims have removable
wheel covers. Use the removal tool to
hook in and pull off any full-wheel wheel
covers. Alternatively, the wheel covers
can be pulled away by hand.
5. Screw together the towing eye with the
wheel wrench* to the stop position.
IMPORTANT
The towing eye must be screwed all the
way into the wheel bolt wrench.
6. Remove the plastic caps from the wheel
bolts with the intended tool.
7. Loosen the wheel bolts ½-1 turn anti-
clockwise with the wheel wrench.
WARNING
Never position anything between the
ground and the jack, nor between the jack
and the car's jacking point.
8. There are two jacking points on each side
of the car. Wind up the jack so that the
flange in the bodywork ends up in the
notch in the head of the jack.
IMPORTANT
The ground must be firm, smooth and
level.
9. Lift the car so that the wheel is free.
Remove the wheel bolts and lift off the
wheel.
To Next Page
Loading...
