Vonluce CFN-1394 - Safety Information

3
• Read ALL these instructions carefully before installation and use.
ONLY install and use this fan in accordance with these instructions.
Keep these instructions for future reference and provide them to anyone who will use or service
this fan.
• To reduce the risk of electric shock, ensure electricity has been turned o󰀨 at the circuit breaker
or fuse box before beginning.
• All wiring MUST be in accordance with national and local electrical codes.
Electrical installation should be performed by a qualied licensed electrician.
• This fan is suitable for use with solid-state speed controls.
• To reduce the risk of personal injury, ONLY use the fasteners provided with the junction box for
mounting to the junction box.
Most junction boxes commonly used for the support of lighting xtures are NOT acceptable for
fan support and may need to be replaced.
Consult a qualied electrician if in doubt.
• The junction box and support structure MUST be securely mounted to create a level surface within
10° of horizontal and MUST be capable of reliably supporting a minimum of 50 pounds (23 kg).
ONLY use UL listed junction boxes marked "FOR FAN SUPPORT".
• After electrical connections are completed, spliced conductors should be turned upward and
pushed carefully up into the junction box.
The wires should be spread apart with the grounded conductor and the equipment-grounding
conductor on one side of the junction box.
• The fan MUST be mounted with a minimum clearance of 7 feet (2.5 m) from the trailing edge
of the blades to the oor.
• DO NOT use the reverse switch while the fan blades are in motion.
To prevent damage and ensure long use, turn o󰀨 the fan and wait for the blades to stop before
reversing the direction.
• DO NOT place objects in the path of the blades.
• Exercise caution when working around or cleaning the fan.
• Use a soft dry cloth to clean the fan body and blades.
DO NOT use water or detergent.
• The electrical diagrams provided herein are for reference only.
Switches MUST be UL general use switches. Refer to their separate instructions for proper
assembly.
• NEVER bend the blades for any reason.
• NEVER replace any parts with nonidentical or unauthorized ones.
Safety Information