A5P | 01
Assemble the appliance as instructed on the previous page.
Ensure the SPEED CONTROL DIAL is at the ‘0’ position before connecting the Stand Mixer to a suitable
mains socket. The LED light around the SPEED CONTROL DIAL will illuminate and ‘ash’ blue.
Add the ingredients into the MIXING BOWL. Do not exceed the 4.5L maximum capacity as indicated. To
prevent possible spillages, we recommend you keep ingredients below 3.L.
Push the TILT RELEASE LEAVER to lower the MIXER HEAD.
Choose the appropriate setting for your ingredients using the guide in the ‘Speed Control’ section above.
NOTE: For most recipes, it is better to begin mixing on a slower speed until the ingredients begin combining,
then move to the appropriate speed range for the particular task.
NOTE: When mixing larger quantities, you may need to increase the speed due to the amount of mixing
required and the larger load on the appliance.
Add ingredients during operation through the port in the SPLASH GUARD.
IMPORTANT: Should the Stand Mixer overheat, a thermal cut out switch will activate and shut down the
appliance. Unplug and allow to cool for 30 minutes before using again.
OPERATION
TROUBLSHOOTING
STAND MIXER WILL
NOT START
THE MOTOR SOUNDS
LABOURED
ATTACHMENTS ARE
COMING LOOSE
STAND MIXER
IS VIBRATING
EXCESSIVELY
MIXING BOWL HAS
COME LOOSE DURING
OPERATION
Check the appliance is correctly connected to the mains.
Thermal cut-out may have activated. Allow the Stand Mixer to
cool before switching back on.
Refer to the ‘ASSEMBLY’ section for correct assembly.
The mixture may be too thick. Add a small amount of liquid to
loosen the mixture.
Too much mixture has been made in the Mixing Bowl. Do not
exceed maximum capacity (4.5L)
Refer to the ‘ASSEMBLY’ section for correct assembly instructions.
Turn the SPEED CONTROL DIAL to a slower speed setting.
Stop the appliance, lift the MIXER HEAD and remove the mixture from the
accessory. Add some liquid to the mixture before resuming.
Refer to the ‘ASSEMBLY’ section for correct assembly instructions.
Ensure the bowl is locked into position prior to use.
To Next Page
Loading...
