21
Saving to a different location (Copy)
Sometimes you may want to save your preset to a new location. This is useful when you want
to start with an existing preset and just change one or two things. Also, it allows you to copy
presets from one location to another.
To copy a preset to a new location, first select the original preset. Then enter Edit mode by
holding down [EDIT] until the Edit LED comes on. Then press [SELECT 2] until you see:
The first digit (bank#) will be flashing. Press [-/NO] or [+/YES] to select the new bank. Now
press [CURSOR 4] and the second digit (preset# within the bank) will flash. Use [-/NO] or
[+/YES] again to set this number. Then press [EDIT] and the display will flash alternately
between:
and the name of the PRESET currently in your chosen location. This will keep you from acci-
dentally writing over a preset you want to keep. You can press [+/YES] to save or press [-/NO]
to go back and choose a new location.
OVERWRITE Y/N
SAVE TO 01
To Next Page
Loading...
Need help?
General
