Voodoo Lab PX-8 PLUS User Manual

8
2) Use buttons #1 and #2 to set QS function:
QS Enabled Interval LED #2 LED #1
No None OFF OFF
Yes Short OFF ON
Yes Long ON ON
3) Remove power when finished.
MIDI > Enable Message Types
You can select whether the PX8+ responds to MIDI Program Change (PC), Control
Change (CC), both message types, or none.
NOTE: When using with Voodoo Lab Ground Control Pro, you must disable both PC
and CC.
The default is both PC and CC are disabled.
1) Apply power while holding down button #1. The LEDs will flash until you release the
button.
2) Press buttons #1 and #2 to select message types:
MIDI Message Type LED #2 LED #1
None* OFF OFF
PC only OFF ON
CC only ON OFF
Both PC and CC ON ON
*None is the correct setting for Voodoo Lab controllers only.
3) Remove power when finished.
MIDI > Set Channel
MIDI Program Change and Control Change messages include a channel number, 1-16.
PX8+ will only respond to messages received on its specified channel.
The default MIDI channel is 1.
NOTE: When PX8+ is being controlled by a Voodoo Lab Ground Control Pro, the MIDI
channel setting is ignored.

Voodoo Lab PX-8 PLUS Specifications

General

Brand	Voodoo Lab
Model	PX-8 PLUS
Category	Music Pedal
Language	English