Need help?Do you have a question about the Voodoo Lab PX-8 and is the answer not in the manual?
General| Number of Loops | 8 |
|---|---|
| True Bypass | Yes |
| MIDI Control | Yes |
| Presets | 128 |
| Input Impedance | 1M Ohm |
| Power Supply | 9V DC |
| Switching Type | Relay |
| Power Requirements | 200mA |
Describes the PX8's top panel controls and indicators, including buttons and LEDs.
Details the rear panel connections and ports for audio, power, and MIDI.
Explains the power requirements and connection for the PX8, including phantom power.
Describes MIDI input and output connections for controller integration and chaining devices.
Details the audio loop connections, including insert points and overall signal flow.
Covers basic loop toggling, LED indicators, and the Quiet Switching feature.
Explains how to enable and use the PX8's built-in preset recall without external controllers.
Details how to use PX8 with Commander, Ground Control Pro, and other MIDI controllers.
Describes saving and recalling presets using MIDI Program Change messages.
Configures PX8 to respond to MIDI Program Change and Control Change messages.
Sets the MIDI channel for PX8 communication, ignoring if controlled by Voodoo Lab units.
Selects which CC number groups control PX8 loops for instant access.
Adjusts the Quiet Switching feature for silence during loop changes.
Details the procedure to enable and configure the PX8's preset mode.
To Next Page
