Set MIDI Channel
MIDI Program Change and Control Change messages include a channel number, 1-
16. The PX8 will only respond to messages received on its specified channel.
The default MIDI channel is 1.
NOTE: When the PX8 is being controlled by a Voodoo Lab Ground Control Pro or
Commander the MIDI channel setting is ignored.
1) Apply power while holding down button #2. The LEDs will flash until you release
the button.
2) Press buttons #1 through #4 to select the MIDI channel:
MIDI Channel LED #4 LED #3 LED #2 LED #1
1 OFF OFF OFF OFF
2 OFF OFF OFF ON
3 OFF OFF ON OFF
4 OFF OFF ON ON
5 OFF ON OFF OFF
6 OFF ON OFF ON
7 OFF ON ON OFF
8 OFF ON ON ON
9 ON OFF OFF OFF
10 ON OFF OFF ON
11 ON OFF ON OFF
12 ON OFF ON ON
13 ON ON OFF OFF
14 ON ON OFF ON
15 ON ON ON OFF
16 ON ON ON ON
3) Remove power when finished.
Select MIDI Control Change
Each MIDI Control Change (CC) message includes a controller number, which
specifies which PX8 loop to turn on or off. You can select from four different groups
of CC numbers.
The default group is CC numbers 80-87, which means that 80 controls loop #1, 81
controls loop #2, 82 controls loop #3, 83 controls loop #4, 84 controls loop #5, 85
controls loop #6, 86 controls loop #7, and 87 controls loop #8.
To Next Page
Loading...
Need help?
General
