Ceramic Master E20 en v1 11
HINTS
The content of each program can be viewed during the
performance. For this purpose the MFK should be
turned.
The parameter values are displayed in series and stay on
the display for 3 seconds. However, if during this time the
button is pressed, the values are displayed while this
button is pressed.
Values of the parameters FIRE RATE, FIRE TEMP и FIRE
TIME can be changed during the execution of the
program. This can be done with the buttons PROG, ESC
and and with the turning of the multifunctional knob
MFK.
By pressing the button PROG during program execution,
display shows the value of the parameter FIRE RATE and
by MFK the programmed value can be changed.
If you do not respond within the next three seconds, the
display shows the current stage of program execution.
In the same way, by pressing the ESC key can be changed
parameter FIRE TEMP, and by button you can change
the parameter FIRE TIME.
When programming the temperature conditions for
parameters IDLE TEMP, DRY TEMP and FIRE TEMP the
program temperature cannot be lower than this of the
previous parameter and at the same time higher than
this of the next parameter.
There is a possibility for fast changing of parameters
which have TEMPERATURE and TIME dimensions. When
you push the button and rotate the MFRK the value
will change by 100 points, and by pushing and rotate
the MFRK the value will change by 10 points.
To Next Page
Loading...
