Vornado EVDC300 - How to Use

10 English
1. Position humidier to not blow directly on objects or plants. Plug
power cord into standard grounded wall outlet.
2. To turn humidier on touch . The
humidier will default to LOW fan speed
and 50% humidity. Set humidity level by
touching -/+ until the desired humidication
level appears on the display. If Continuous
is selected, CO will appear on the display
and the humidier will run continuously.
3. Touch to select Turbo (HH), High (HI) or
Low (LO) fan speed. The will illuminate
blue. The selection will ash for ve
seconds, then set and return to selected
humidity level.
4. You may also select Energy Smart™
mode and ES will ash on the display for
ve seconds, then set before returning to
the selected humidity level. The will
illuminate green. In Energy Smart™ mode,
Continuous (CO) and Turbo (HH) fan speed
are disabled.
Note: The LED Display dims after 20 seconds of inactivity.
5. Once settings are changed from rst use default, they are saved
when powering humidier off.
6. If unit is unplugged, during next use, settings will default to LOW fan
speed, 50% humidity.
WARNING: Avoid nger contact with the fan blade, which is accessible
on the underside of the Power Head. Before dissasembly or removing
the Power Head from the humidier, wait until the fan blade comes to a
complete stop.
HOW TO USE
TURBO (HH)
Operation for fast humidication of larger rooms. Turbo-speed
operation will evaporate 3 gallons of water (+/- 10%) in 24 hours of
continuous operation. This assumes room conditions of 70°F and
30% relative humidity.
HIGH (HI)
Operation for moderate humidication of mid-size to large rooms.
LOW (LO)
Operation for quiet, nighttime use or smaller rooms. On
Low operation, your humidier may run without relling for
extended periods.
HUMIDITY – 40%–60%
The humidier will operate until the desired humidity level is
reached. At this point, the Fan will turn off. If the Fan does not
turn on, the humidity setting may be lower than the room humidity
level. Increase the humidity set point until the Fan turns on. This is
an indication of the level of humidity already in the room.