10 English
Troubleshooting
Unit is not plugged in. Plug Power Cord into electrical outlet.
Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker /
ground fault interrupter, or replace fuse (See OPERATING TIPS).
The unit has overheated. Automatic Safety Shut-Off has initiated (See RESETTING YOUR VORNADO HEATER).
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Ensure unit is set to High Heat and thermostat is set to highest Temperature setting.
Close all doors and windows to trap heat.
Allow the unit to fully circulate the heat throughout the room, may take several minutes.
Power off and unplug the unit. On the bottom of the unit, there is a black disk. Push in 4-5 times ensuring it
is not stuck. Set unit down on flat surface. Be sure power cord is not under unit. Plug unit in and power on.
Turn to highest heat setting.
Unit fails to power on.
Unit is not producing
sufficient amount of heat.
Unit power on but there
is no heat.
Problem Possible Cause and Solution
To Next Page
Loading...
Need help?
General
