5
English
Operate this heater only in its upright position.
Do not operate this heater on an elevated surface such as a shelf or
desktop. Use only while placed on the floor.
This heater is equipped with a thermal safety shut-off system,
designed to turn off the heater when an internal overheating
condition is detected (see How To Use “RESETTING YOUR
VORNADO HEATER,” to determine how to check and reset the
heater).
Do not use this heater on a circuit that has a variable speed device
operating, such as a blender or a variable speed fan.
Do not use heater to dry human or animal hair/fur or articles of
clothing.
This product must be grounded. If the product malfunctions,
grounding provides a path of least resistance for the electric current
to reduce the risk of electric shock. The 3-prong plug must be
inserted into a grounded outlet that has been properly installed
in accordance with all electric codes and ordinances. If you are in
doubt as to whether or not an outlet is properly grounded, contact a
qualified electrician.
This heater operates with an infrared remote control. Interference
between this remote and other remote-control-operated electrical
appliances in your home is possible.
CAUTION: In order to avoid a hazard due to inadvertent resetting of
the thermal cutout, this appliance must not be supplied through an
external switching device, such as a timer, or connected to a circuit
that is regularly switched on and off by the utility.
This heater is for use on 120 volts. The cord has a plug as shown at A
in Figure 65.1. An adapter as shown at C is available for connecting
three-blade grounding-type plugs to two-slot receptacles. The green
grounding lug extending from the adapter must be connected to
a permanent ground such as a properly grounded outlet box. The
adapter should not be used if a three-slot grounded receptacle is
available.
Do not use this heater in an RV, a boat, or in any application where a
DC/AC converter is converting battery power to AC power.
Do not use the heater on any Ground-Fault Circuit Interrupted (GFCI)
circuit. A GFCI circuit has a reset button in the middle of the outlet.
Do not use this heater on a surge protected circuit.
Do not use the heater with any kind of timer to turn the unit on or off.
Do not use this heater on a circuit that is shared with a high power
device, such as a vacuum or a circular saw.
CAUTION: A loose fit between the outlet (receptacle) and plug may
cause overheating and distortion of the plug. Discontinue use of
the product. Contact a qualified electrician to replace loose or worn
outlet.
Figure 65.1
SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THIS HEATER.
To Next Page
Loading...
Need help?
General
