Vortex ROK DVS J - Standard Carburettor Set up; 2.5 Mm allen Wrench; Flat Screwdriver

ENGINE ASSEMBLING
DVS-Junior
15
2.5mm Allen Wrench
Flat S crew d r i ver
Now assemble the carburettor. All parts
needed are in the accessory box.
The standard set up in the carburettor is already to run
your engine.
Assemble aluminium air box adapter to the carburettor.
Fit the hose clip to the rubber manifold. Insert
the carburettor in the rubber manifold and
tighten the hose clamp tight with the flat
screwdriver.
Standard Carburettor Set Up
Type specifics
Carburettor Dell’orto 24mm WHST 24BS
Gas Valve 50
Conic Needle D55
Spray AQ270
Minimum Jet U43
Maximum Jet 110