Vorwerk TM5 - Changing the protection grid on the bottom

50 Changing the protection grid
CHANGING THE PROTECTION GRID
Changing the protection grid on the bottom
To install the protection grid on the bottom of the Thermomix
®
, disconnect
the Thermomix
®
from the mains power supply. Remove the mixing bowl and
tilt the Thermomix
®
as shown
1
. Take the protection grid for the bottom
2
.
It has an oval bump that must face the bottom of the Thermomix
®
3
.
Lay the insect mesh under the upper ridges, then press down until you hear
that the grid has locked in place
4
.
To remove the protection grid, disconnect the Thermomix
®
from the mains
power supply first. Remove the mixing bowl and tilt the Thermomix
®
in
the same way as when you inserted the grid. There is a tab at the left of the
protection grid. Pull on this to remove the protection grid.
1 2 3
4