To reassemble:
1. Ensure top cover (with screen) is in normal position
2. Screw fluid tank onto front bullhead, ensuring center pin is in place
3. Ensuring good alignment, gently push bulkhead and tank assembly in place
4. Unscrew fluid tank, and screw the 3 screws back into place
If the MicroFogger gets oily from small droplets of fog liquid on the exterior, you can
wipe it clean with a moist paper towel.
If the fluid tank gets oily or significantly wet with fog liquid, take it off of the device and
wipe it clean. You can also wash it with clean water, but ensure you allow it to fully dry
before re-installing, to prevent excess “spitting”
Troubleshooting
Before attempting any troubleshooting steps, please reset the MicroFogger first by
holding the select and mode buttons at the same time for 10 seconds until “full reset” is
displayed on the screen.
No smoke is emitted even though the device activates - First, check that the smoke
density power isn’t too low to notice. Next, ensure the fluid tank is screwed on
sufficiently tight. If it is, attempt the following:
-Cut the cotton part off one end of a Q-tip, keeping the plastic handle
-Insert cut end of handle into the MicroFogger’s barrel
-Apply some downwards pressure to re-seat any loose connections
Fluid tank leaking from ends - If you’ve over-filled the fluid tank, this may cause some
leaks while the pressure equalizes. Wipe away any excess fog liquid and perform Q-tip
cleaning method prior to installation on device. If leaking persists, you may have a worn
heating coil, and needs to be replaced.
MicroFogger won’t turn on - First, ensure that the battery is installed in the correct
direction and the switch is ON. If the screen does not turn on, turn the switch OFF and
plug the MicroFogger in to charge for several hours. If the device does still does not run
on, the battery may have been over-discharged and needs to be swapped out.
MicroFogger won’t charge - First, ensure that the battery is installed in the correct
direction. If the orange charging light doesn’t turn on, try using another charger and
USB-C cable to diagnose whether it is an issue with the MicroFogger or not.
MicroFogger activates on when the placed on charge - This can occur when the charge
lock setting is OFF and control cable setting is ON. Revert the settings to their default
values.
To Next Page
Loading...