feature and can be dangerous if used improperly. We recommend keeping it
ON at all times.
Charge lock ON/OFF - Sets if the MicroFogger can be activated while
charging. Keep this setting ON unless you are both charging and triggering
simultaneously. Turning it OFF may result in unintentional activation while
charging.
Control cable ON/OFF - Toggles the ability to use the USB port as a trigger.
Keep this setting OFF unless using the control cable accessory
Info - This screen will display the software version number. Press select to see total
runtime and battery voltage
Normal operation
Holding the SMOKE button when the MicroFogger is on will begin smoke production. To
maximize heating coil lifespan, we recommend a 10 second limit on continuous use at
high power settings, with a few seconds between each burst. Prolonged continuous use
on a cold start can cause excessive heating coil wear.
Never run the MicroFogger without fog liquid in the fluid tank. This will instantly
wear out the heating coil and make the smoke smell burnt. In extreme cases, if you
keep running the MicroFogger after this indicator, small burning fragments of absorbent
material may be ejected out of the nozzle, as the coil burns out. If the heating coil has
worn out and the smoke smells burnt, immediately stop use and see the coil
replacement instructions below.
We recommend keeping the MicroFogger mostly upright during use. This position
allows the coil to optimally absorb the liquid, even if the tank is near-empty. If you
require smoke output in a downward or sideways direction, we recommend using the
hose adapter accessory to re-direct the smoke through a hose. If the fluid tank is >90%
full, the MicroFogger can be used in any orientation,
Avoid prolonged use at low smoke speeds as this can cause the MicroFogger to “spit”.
Always use the Q-tip method in the quick start guide to prevent “spitting” after storage or
tank filling.
When finished, remember to turn the toggle switch OFF. Leaving the MicroFogger
ON for extended periods of time may cause permanent battery damage and
unpredictable behavior. Unscrew the fluid tank when you are done with using the device