72
ENGLISH
OPERATIONS
How to Use Effects
There are 4 on-board DSP digital effects: ECHO
, FLANGER
,FILTER
, and SKID
.To activates an effect,
simply tap the desired Effect button.
ECHO Effect - The Echo effect adds an echo to your output signal.
FLANGER Effect - The Flanger effect distorts the output signal and creates an effect similar to the frequency
phasing in and out of each other. This frequently applied effect is similar to the Phase
effect, but slightly more harmonious, emphasizes the upper pitch more and is reminiscent
of a flying aircraft.
Filter Effect - The Filter effect tweaks the original sound to add different tonal definition.
SKID Effect - This effect to simulate traditional vinyl turntable turn on and turn off sound effect. You can adjust
X parameter to determines the acceleration speed until full playback speed is reached when the
PLAY/PAUSE button is pressed. You also can adjust Y parameter to determine the deceleration
speed until play stops when the PLAY/PAUSE button is pressed.
Manually Adjust X (Time)
Press the X (TIME) button
and use the JOG WHEEL to adjust the parameter.
Automatically Beat Sync Adjust (FX Auto Beat Sync)
Press HOLD button
for 1 sec and the LED is flashing to active FX Auto Beat Sync mode. In the FX Auto Beat
Sync mode, you can press X button
to decrease beat sync or press Y button
to increase beat sync. (The
Beat Sync ratios can be changed from 1/32 to 1/16, 1/8, 1/4, 1/2, 3/4, 1/1, 2/1, 4/1, 8/1, 16/1, 32/1).
Adjust Y (Level/Depth) Parameter
The Y parameter controls the depth, feedback or level, depending on the effect. Press the Y button
and rotate
the JOG WHEEL to adjust the parameter. Each time you only can adjust one parameter.
: As soon as the X Parameter button
or Y Parameter button
are activated, the Scratch mode is
temporarily deactivated.
Vinyl and Scratching
Under Vinyl Mode or Auto Cue Scratch
In Vnyl mode or Auto Cue Scratch Mode the inner JOG WHEEL will simulate the behavior of a turntable. The top
surface of the WHEEL is touch-sensitive. Putting your hand on the WHEEL will stop playback, as it would on a
vinyl record. Once playback is stopped, moving the WHEEL back and forth will create a scratching effect, like on
an analog turntable. Under Auto Cue Scratch mode, simply touch the surface of the JOG WHEEL and player will
immediately return to the last set cue point and playback without music interruption.
: To activate Vinyl mode, press VINYL Mode button
to the Vinyl Mode. To activate Auto Cue
Scratch Mode, press A.CUE button
to the Auto Cue Scratch mode.
To Next Page
Loading...