1
3800 Richardson Road South • Hope Hull, AL 36043
Tel: 334-284-8665 • Fax: 334-613-6302
http://www.miltope.com
nMAP2 Wireless
Quick Start Guide
M365-780, 5 January 2015
The nMAP2 Wireless Access Point is a wireless communication device designed for use in the airborne environment. The nMAP2 wireless access
point is not used in ground-based locations such as a home or office. The nMAP2 Wireless Access Point must be installed by personnel qualified
and authorized to install equipment aboard aircraft. This quick start guide introduces the 802.11n/ac Multifunction Access Point, 2
nd
Generation
(nMAP2) part number 903920-1 and provides basic setup information for use as a stand-alone access point using nMAP2 Wireless Access Point
Operating Software part number 999239. After following the directions provided in this quick start guide, see nMAP2 Wireless Access Point
Operating Software Operator’s Manual M365-768, available from VT Miltope, for detailed instructions to configure the operating software for your
application.
INPUT POWER/DISCRETE CONNECTOR J1 (RED)
LAN PORT 2 CONNECTOR J2 (BLUE)
MOUNTING HOLES
(6 PLACES)
SPECIFICATIONS
INPUT POWER 97 -134 VAC, 360 - 800 Hz OR 18 - 32 VDC, 28 W MAXIMUM
-15°C to +70°C
OPERATING HUMIDITY 5% TO 95% RELATIVE HUMIDITY, NON-CONDENSING
OPERATING ALTITUDE ATMOSPHERIC PRESSURE EQUIVALENT TO -15,000 TO +15,000 FEET
LAN PORTS 1 AND 3 CONNECTOR J3 (GREEN)
8-32 THREADED GROUND POINT
0.28 INCH MAXIMUM SCREW DEPTH
INDICATOR
HARDWARE OVERVIEW
To Next Page
Need help?
General